Sliding Door Cable Repair Part Assembly Kits Compatible with 2011 2012 2013 2014 2015 2016 2017 Honda Odyssey, Left and Right Side

After spending an hour or more to get to the door winder cable I found a broken pulley within the motor which has no aftermarket replacement. I tried to fix the pulley with JB Weld unsuccessfully (worked for ~1 month) and ended up having to cough up the cash for the winder + door rollers + circuit board.

This is not a complete kit and the ends do not match where they are supposed to on the part they connect to. I would not waste your money on this.

Worked well. Better than paying the honda dealer 1,000 to do it.

Replacing the cables on my Odyssey was about a 6-hr job, but I got it done and it's working. The cables were slightly too long, and I ended up having to cut about 2 inches off the end for them to fit in the pulley inside the motor housing. This was a nerve-wracking decision for me, as I could only estimate how much I needed to shorten the cables. If you find yourself having to shorten, just do a small amount, and make sure to the cut the same amount off both cables.The included ferrules seem a bit small, which makes me nervous. So far, they're holding up, but it wouldn't surprise me if one of these cables gets pulled out of the pulley.There's quite a few reviews saying these cables didn't last more than a few months, so I'll follow up in the future with how they're working out.

I was glad I bought 2 sets in anticipation of the other door going out. Only 1 cable from each kit was long enough, and the ferrules supplied did not fit the cables, but were also too skinny to be held by the cable spool. I bought my own ferrules and was able to make it work.

Not too easy to install but it worked and saved me a lot of money

Seems like it will work but the end cap that goes into the pulley isn’t as big as the factory cable. Meaning when you get it set, it may work temporarily but will eventually pull out of the pulley system and unravel. A waste of time and money. We tried to crimp it to see if we could salvage the cable and make it work but it wouldn’t work.

Works as advertised. Thanks!

Amélioration serait de mettre des embouts de différents formats à l’emballage

It looks close enough to OEM, but after many tries I thought I must have missed something in the routing of the cables. It had too much slack.A little scared of messing it up, I ended up cutting about 1.5" off one end and got the tension I needed to make it work well.Having to cut is not ideal because after cutting it was quite difficult to fit the ferrule. You need a really clean cut. But luckily there were extra ferrules for this trial and error...In an ideal world, these cables should be the correct length for the job. It's for specific vehicles (not universal) so it isn't much to ask. The time lost on this imperfection, and the risk of getting it wrong are too high for the work it takes to get to the motor/pulley system.

Good quality, but the ferrules are no good. You need to get creative and find other ferrules to secure the cable to the spool. The length is perfect.

Perfect size and quality of the wire was good. No difficulties in installing but quality of the ferrules was just ok.

the wire is a bit too thick and it is also too long, we need to cut it manuallysince the wire is too thick and easily scrumble inside the wiremy van is honda odyssey 2015not recommend